The osu!catch catcher: catcher, catcher-fail, and the dash sprites

In osu!catch, the player is the catcher at the bottom of the screen, not a cursor. That character is a small set of sprites: the idle catcher, the fail pose, and the dash / walking frames. Fruit sprites (fruit-apple, fruit-grapes, and the rest) are a different family and are described elsewhere. This note lists the catcher files and a short test before you pack the .osk.

The files

The catcher is the hit target. A very wide or decorative sprite makes it hard to tell where the plate is. Keep the catching edge readable, and keep the character’s width close to what you expect from the default catcher so timing does not feel off.

What usually goes wrong

  1. Skinning only the fruit. A custom apple on the default catcher, or the reverse, is obvious the moment a map starts.
  2. Idle and dash frames that do not share an origin. The character pops left or right when you dash.
  3. A fail pose in a completely different style. The fail screen then looks like a second skin.
  4. Testing only in osu!standard. These files never appear in standard or mania.

A short test

Install the skin, open a short catch map, and stand still, walk, and dash under a few fruit. Confirm the plate is readable, the dash does not jump sideways, and dropped fruit still makes sense against the character. Fail once and check the fail pose. You can compare readable catcher sets in complete skins on osuskins.org.

The job of these files is only to make the catcher a clear, stable target. If you can dash and still tell where the plate is, they are finished.


Notes by ZentaoLabs. Skin library: osuskins.org.